All Motion Alarm; Sandblast Protection Kit; Air Line To Platform; Driving And Platform Work Lights - Snorkel AB60J Operator's Manual

If the power was on, repair or replace the re-

ceptacle.

All Motion Alarm

The machine may be equipped with an all motion
alarm.
Operate machine functions to ensure that the alarm

sounds to warn personnel in the area that the aerial
platform is in motion.

Sandblast Protection Kit

The optional sandblast protection kit protects the cylinders
from abrasion while sandblasting or from paint overspray.
Rubber covers protect each cylinder rod as it extends
and retracts. The covers prevent sand and paint from
damaging the cylinder seals and rod.
• Inspect the covers while operating the machine to
ensure they are securely fastened and completely
cover the cylinder rod. Make sure there are no holes
in the covers.

Air Line to Platform

The machine may be equipped with an optional air line
to the platform.
• Inspect the components, including the air line, mount-
ing hardware, and the caps on the input and output
connectors, etc. to verify all components are present
and are in working condition.

Driving and Platform Work Lights

The machine may be equipped with driving lights and/or
platform work lights.
• Turn the engine on and use the switch on the back
of each light to momentarily turn it on to see that it
works.

Tow Kit

The machine may be equipped with an optional tow kit.
• Inspect the components, including the tow bar, steer
arm, and chains, etc. to verify all components are
present and are in working condition.

Platform Glazier Package

To inspect the platform glazier package:
1. Inspect the glazier trays (refer to Figure 7.23) to make
sure they are in good condition and are not bent or
distorted.
2. Inspect the keeper pins to make sure they are in good
condition and are not bent or distorted.
AB60J – 0181972
Chapter 7 – Prestart Inspection
Straps
Keeper Pins
Figure 7.23 – Platform
3. Make sure the straps and padding are in good condi-
tion and are not worn, cut or frayed.

Platform Control Cover

The machine may be equipped with an optional platform
control cover.
Inspect the cover to ensure it fits properly over the

control panel.

Placards and Decals

To inspect the placards and decals:
1. Inspect all safety and operational placards and de-
cals. Make certain they are in place, in good condi-
tion, and are legible.
2. Clean the placards and decals with soap and water,
and a soft cloth if the words or pictures cannot be
seen.
Caution
Solvents may contain hazardous ingredients. Follow
the manufacturer's label for proper use and disposal.
Wear protective gloves and splash-proof safety
glasses when using solvents.
3. Remove wet paint overspray with a natural biode-
gradable solvent and a soft cloth.
4. Replace any missing, damaged, or illegible placards
or decals before operating the aerial platform.
Placard and decal kits are available from Snorkel.
The safety related placards and decals are illustrated on
the following pages.
Padding
Trays
39