Connecting The Patient Circuit - Breas iSleep 20+ User Manual

Connect the power cord to the
3
mains supply.

6.4 Connecting the Patient Circuit

Read the chapter "Usage of Patient Circuit" on page 10 carefully to make
sure all conditions are fulfilled and considered.
Connect the patient tube to the
1
air outlet.
Connect the other end of the patient tube to the mask and the ventilation
2
valve, if applicable.
Mask Leakage
The leakage from the mask should be at least 12 l/min at 4 cmH
re-breathing of exhaled air. The recommended mask leakage is 20-40 l/min at
10 cmH
This leakage may be achieved by:
• small holes in the mask
• an adjoining ventilation valve
In order to receive a suitable leakage the Breas iMask™ Nasal CPAP Mask is
recommended.
30 Preparing the iSleep 20+ for Use
iSleep 20+ users manual
O pressure.
2
O, to prevent
2
Doc. 004270 En-Eu T-3b