5
Using the iSleep 20+
5.1 Checking the iSleep 20+ before Use
Always make the following checks before using the iSleep 20+:
Connect a cleaned or a new patient circuit to the iSleep 20+.
1
Connect the iSleep 20+ to the mains supply.
2
Check patient settings.
3
Switch on the iSleep 20+ by pressing the Start/Stop button on the front
4
panel. Ensure that the iSleep 20+ is running.
Put on the mask and adjust its fit.
5
Ensure that the settings are adjusted as prescribed.
6
The iSleep 20+ is ready for use.
5.2 Switching the iSleep 20+ On and Off
Make sure the power supply
1
is connected.
Turn on the iSleep 20+ by press-
2
ing the Start/Stop button on the
front panel for 2 seconds.
This
iSleep 20+ between standby and
operating mode.
The iSleep 20+ is connected to a power supply when the LCD display is lit up.
Doc. 004270 En-Eu T-3b
operation
switches
the
Using the iSleep 20+
iSleep 20+ users manual
21