Using An External Battery - Breas iSleep 20+ User Manual

5.5 Using an External Battery

The iSleep 20+ can be powered from:
• The Breas external EB 2 Battery Pack.
• A 12 V external power source. The iSleep DC converter 12-24 V needs to be
used.
Connect the external DC cable to
1
the iSleep 20+. Make sure it is fitted
correctly.
Connect the other end of the cable to the battery source.
2
• Always make a function check to test the battery condition before operat-
• The battery must be disconnected when the iSleep 20+ is switched off,
Battery Operation Time
The operation time is dependent on the battery condition, its capacity, the ambi-
ent air temperature and the iSleep 20+ pressure setting.
The operation time is based on the following settings:
26 Using the iSleep 20+
iSleep 20+ users manual
ing the iSleep 20+ from an external battery source.
otherwise the battery will be discharged.
S
ETTING
Humidifier setting
CPAP pressure
Ambient temperature
Altitude
Battery status
B
ATTERY TYPE
EB 2 (24 V, 7.2 Ah)
V
ALUE
5 or Off
10 cmH O
2
20°C (68°F)
Sea level
New battery fully charged
H O
UMIDIFIER PERATION
Off 13 h
T
IME
Doc. 004270 En-Eu T-3b