Usage Of Patient Circuit; Usage Of Filters - Breas iSleep 20+ User Manual

2.4 Usage of Patient Circuit

• Only use the iSleep 20+ with a mask, patient tube and ventilation valve (if
• Do not breathe in the connected patient circuit unless the iSleep 20+ is
• Do not use patient hoses or tubes made of electrically conductive or static
• Patient connected parts and filter must be replaced regularly to ensure cor-
• If the patient is using a full face mask (covering mouth and nose), the mask
• Make sure that the ventilation holes in the mask or the adjoining ventilation
• At low CPAP pressures, the air flow through the ventilation holes in the

2.5 Usage of Filters

• Always use the iSleep 20+ with a patient air inlet filter installed. Only use
• Replace or clean the filters regularly to ensure correct function of the
• When operating the iSleep 20+, make sure that the air inlet and the filter is
10 Safety Information
iSleep 20+ users manual
applicable) recommended by Breas Medical AB and your health care pro-
fessional.
turned on and operating properly.
material.
rect function of the iSleep 20+. All replaced parts must be disposed of
according to local environmental regulations regarding the disposal of used
equipment and parts.
must be equipped with a safety entrainment valve.
valve are never blocked or obstructed. These devices are used for ventilat-
ing the mask in order to prevent re-breathing of exhaled air. Re-breathing
of exhaled gases for longer than a few minutes can, in some circumstances,
lead to suffocation.
mask or the adjoining ventilation valve may be inadequate to clear all
exhaled gases from the mask. Some re-breathing may occur.
filters that are specified in this manual.
iSleep 20+, especially when changing patient. Failure to replace or clean a
dirty filter may cause the iSleep 20+ to operate at higher temperatures than
intended.
not obstructed or occluded.
Doc. 004270 En-Eu T-3b