Placing The Isleep 20; Connecting The Isleep 20+ To The Mains Supply - Breas iSleep 20+ User Manual

6.2 Placing the iSleep 20+

Read the chapter "Environmental Conditions" on page 9 carefully to
make sure all conditions are fulfilled and considered.
Place the iSleep 20+ on a solid,
1
flat surface. The iSleep 20+ should
be placed lower than the patient in
order to prevent the device from fall-
ing on the user.
Make sure that nothing can block
2
the patient air inlet at the side of the
iSleep 20+.

6.3 Connecting the iSleep 20+ to the Mains Supply

Read the chapter "Electrical Safety" on page 8 carefully to make sure all
conditions are fulfilled and considered.
To Connect the iSleep 20+ to the Mains Supply:
Plug the power supply into the
1
power inlet of the iSleep 20+.
Connect the power cord into the
2
power supply.
Doc. 004270 En-Eu T-3b
Preparing the iSleep 20+ for Use
iSleep 20+ users manual
29