Connecting Your Aerial And Satellite; Switching On The Tv - Sony Trinitron KD-32NS200 E Instruction Manual

3

Connecting your aerial and satellite

Connecting a VCR to the TV
Scart lead
(not supplied)
4

Switching on the TV

RF lead
(not supplied)
On/Off button
1.
Connect your existing aerial to the socket marked
on the rear of the TV as shown.
ANALOGUE
2.
Connect your satellite dish to the F-type socket
marked .
1.
Connect your satellite dish to the F-type socket
marked on the rear of the TV as shown.
2. Connect your existing aerial to the RF IN socket on
your VCR.
3. Connect a lead from the RF output of your VCR to
the analogue socket marked
connect a scart lead as shown.
4.
Connect the VCR to the mains socket and switch
on.
5.
Insert a pre-recorded tape into the VCR and press
the 'PLAY' button. This enables the TV to locate
and store the
'Automatically tuning the TV' procedure.
1. Connect the TV plug to your mains socket
(220 -240V AC, 50Hz).
2.
Push in the On/Off button (labelled !) on the front
of the TV.
If the red standby mode indicator on the front of the
TV is lit, press the TV I/
control to switch on the set. Please be patient as
the picture may take a few moments to appear on
the TV screen.
Getting Started
then
ANALOGUE
video channel during
button on the remote
1
Getting Started
the
5