Beam Position Detection; Using The Beam Position Counter - Commodore Amiga A1000 Hardware Reference Manual

BEAM POSITION DETECTION

Sometimes you might want to synchronize the 68000 processor to the video beam that is
creating the screen display. In some cases, you may also wish to update a part of the
display memory after the system has already accessed the data from the memory for the
display area.
The address for accessing the beam counter is provided so that you can determine the
value of the video beam counter and perform certain operations based on the beam
position.
NOTE
The Copper is already capable of watching the display position for you and doing certain
register-based operations automatically. Refer to "Copper Interrupts" below and Chapter
2, "Coprocessor Hardware," for further information.
In addition, when you are using a light pen with this system, this same address is used to
read the light pen position rather than the beam position. This is described fully in Chapter
8, "Interface Hardware."

USING THE BEAM POSITION COUNTER

There are four addresses that access the beam position counter. Their usage is described
in Table 7-5.
- 210 System Control Hardware -