Source Feature - Audiovox AVXMTG10U Instruction Manual

SOURCE FEATURE

DVD
AV1
USB
SD
DVD
When a disc is loading to the DVD player, the program system will switch to DVD mode
directly whatever the CARD or USB and AV is in play condition.
Last Memory for the DVD mode: Every time turning power on, it will play from the point
stopped last time.
At power OFF mode, put into a disc, and it can automatically slot in the disc and turn
power on.
AV1
The unit will accept an audio/video input through the 3RCA jacks located on the rear of
the unit. The audio/video device can be a video game system, video camera, or other
input device.
CARD
Insert a card(compatible with normal SD/MMC/MS) and play content.
Supported format: MP3, JPEG, AVI, MPEG ,
USB
Insert USB and play content.
Supported format: MP3, JPEG, AVI, MPEG ,
OVERHEAD DOME LIGHTS
The Dome Light integrated into the F101 are controlled by a three position slide switch.
Sliding the switch to the ON position will turn the light ON. The OFF position will
prevent the lights from turning ON with the vehicle interior lighting, and the auto
position will allow the lights to turn ON and OFF with the vehicle interior lighting. Refer
to the installation guide for wire connections. Do not leave the vehicle unattended with
the dome light switch in the ON position, as this could result in a discharged battery.
REMOTE SENSOR
The unit incorporates two infrared remote sensors which relay signals from the remote
control to allow the unit to be controlled simply by pointing its remote control at the
remote sensor. The infrared sensor can relay signals from most manufacturer's remote
control to its respective component connected to the AV input, in this case, you must
use the remote control supplied with the component.
etc.
etc.
12
TROUBLE SHOOTING
PROBLEM
IR remote inoperative
Disc won't play
Play starts, but then stop immediately
No sound or distorted sound
Can't advance through a movie
The icon ( ) appears on screen
Picture is distorted
SOLUTION
1. Verify that the batteries in the remote are
fresh.
2. Verify that the remote sensor eye is not
obstructed.
1. Insert a disc with the label side facing up.
2. Check the type of the disc you put into the
disc tray. This DVD only plays DVD, VCD,
audio CD, JPEG, MP3 and MPEG4.
3. Both the unit and the disc are coded by
region. If the regional code doesn't match,
the disc can't be played.
1. The disc is dirty, clean it.
2. Condensation has formed, allow player to
dry out.
1. Make sure your DVD is connected properly.
Make sure all cables are securely inserted
into the appropriate jacks.
2. If you are using 2-channel IR headphones,
make sure you turn on the IR headphone
power, make sure the correct channel(A-B)
is selected.
3. Make sure the modulator is ON and the
proper frequency has been selected.
1. You can't advance through the opening
credits and warning information that
appears at the beginning of a movie
because the disc is programmed to
prohibit that action.
The feature or action cannot be completed at
this time because
1. The disc's software restricts it.
2. The disc's software doesn't support the
feature.
3. The feature is not available at the moment.
4. You've requested a title or chapter number
that is out of the range.
1. The disc might be damaged, try another
disc.
2. It is normal for some distortion to appear
during forward or reverse scan.
13