Download Print this page

Audiovox AVXMTG10U Instruction Manual page 11

10" digital led back-lit monitor with built-in dvd player
Hide thumbs Also See for AVXMTG10U:

Advertisement

GENERAL INSTALLATION APPROACH
1)Decide upon system configuration and options that will be installed.
2)Review all manuals to become familiar with electrical requirements and hook ups
3)Decide upon mounting location of all components and method of mounting
4)Prep the vehicle by removing any interior trim necessary to gain access to vehicle's
wiring as well as all areas wher interconnecting wire harnesses will need to be located.
If any access holes need to be cut into the vehicle, this should be done now as well .
5)Route the wiring harnesses throughout the vehicle as necessary.(Refer to the wiring
Diagrams on this manual as well as the wiring instructions for the individual
components and accessory options being installed). Be sure that all wiring is protected
from sharp edges and is routed in such a manner that pinched when all components and
interior trim are fully installed. Be sure to leave enough slack in the wiring at each
component to allow working room
6)Remove all A/V system components form their packaging and place them loosely in the
vehicle at their respective locations.
7)Connect all components together and verify proper operation of all system functions.
Note: This is best done BEFORE , components have been permanently mounted .
8)After verifying proper operation of the system , proceed to mount of each component
9)When all components are mounted , recheck function of entire system again to ensure
that no wiring was pinched or connected improperly during final installation..
Installing the snap on covers
1.
2.
Shroud
Place the pod on a soft
surfaces to avoid
dannaging the plastic
3.
4.
Screen Back Cab
Pry Tool
16
Disconnect the screen cover
1
2
"A"
Inset the supplied prytoool to "A","B"and "c" snap on cover.
Installing the screen cover
"D"
"D"
"D"
"D"
Open the screen and hook the two tabs"D"on the buttom edge of the screen snap the
opposite side over the bringe
Disconnect the shroud
1
2
Beg in by hooking area "E"(fastener) over the dome light and slide the cover over the
pod The cover will snap in place.
3
"C"
"B"
"E"(fastener)
17

Advertisement

loading