Teo 9104 Installation Instructions Manual page 22

Teo IP Phone 9104 Installation Instructions
redirected to voicemail and the page will not be interrupted. Likewise, if the same or
lower priority page (e.g. Priority 2) is initiated when the phone is on a normal call,
the normal call will not be interrupted. If the same or lower priority multicast page is
in progress when a normal call is placed to the phone, the phone will ring, allowing
the user a choice of remaining on the page or answering the incoming call. If
NORMAL CALL PRIORITY is set to DISABLED, normal calls are never preempted.
4. For each priority paging zone you wish to configure, click a row in the MULTICAST
LISTENERS table. The IP Phone 9104 can be configured to listen to up to 10
multicast zones.
5. Enter a paging zone NAME, IP ADDRESS and PORT. The recommended IP address
range is 239.0.0.2 to 239.255.255.254. Port numbers must be in the range of 1025 to
65535, and each zone should have a unique port number. IP addresses and port
numbers must be consistent between sending and listening devices.
6. To change a paging zone's priority, click arrows in the rightmost column to move a
paging zone up or down in the list.
C o n f i g u r i n g M u l t i c a s
C o n f i g u r i n g M u l t i c a s
1. Click the MULTIFUNCTION KEY SETTINGS tab.
2. Select an unused key.
3. Set the key TYPE to MULTICAST.
4. Enter the paging zone name in the LABEL field to identify the key.
5. Enter the appropriate IP ADDRESS and PORT for the paging zone. The
recommended IP address range is 239.0.0.2 to 239.255.255.254. Port number must
be in the range of 1025 to 65535, and each zone should have a unique port number.
IP addresses and port numbers must be consistent between sending and listening
devices.
When finished with phone configuration, click
It may take a couple of minutes for the configuration to load into the phone.
Page 22
t P a g i n g K e y s
t P a g i n g K e y s
.
13-280143 Rev. A