Notes On Installing In The Rack - Fujitsu PRIMERGY TX300 S4 Operating Manual

Important information
3.5

Notes on installing in the rack

V
CAUTION!
For safety reasons, at least two people are required to install the
rack model because of its weight and size.
Never lift the server into the rack using the handles on the front panel.
When connecting and disconnecting cables, observe the relevant
instructions in the "Important Information" chapter of the technical
manual for the corresponding rack. The technical manual is supplied
with the corresponding rack.
When installing the rack, make sure that the anti-tilt mechanism is
correctly fitted.
For safety reasons, no more than one unit may be removed from the
rack at any one time during installation and maintenance work.
If several units are simultaneously removed from the rack, there is a
risk that the rack could tip over.
The rack must be connected to the power supply by an authorized
specialist (electrician).
If the rack model is integrated into an installation that draws power
from an industrial power supply network with an IEC309 type
connector, the power supply's fuse protection must comply with the
requirements for non-industrial power supply networks for the type A
connector.
TX300 S4
Notes on installing in the rack
Operating manual 35