Transporting The Server; Notes On Installing In The Rack - Fujitsu PRIMERGY RX200 S3 Operating Manual

Transporting the Server

3.4 Transporting the Server
V
CAUTION!
Only transport the server in its original packaging or in packaging that
protects it from impacts and jolts. Do not unpack the server until it is at
its installation location.
If you need to lift or transport the server, ask other people to help you.
3.5

Notes on Installing in the Rack

V
CAUTION!
For safety reasons, at least two people are required to install the
system in the rack because of its weight and size.
When connecting and disconnecting cables, observe the relevant
instructions in the "Important Information" chapter of the technical
manual for the corresponding rack. The technical manual is supplied
with the corresponding rack.
When installing the rack, make sure that the anti-tilt mechanism is
correctly fitted.
For safety reasons, no more than one unit may be removed from the
rack at any one time during installation and maintenance work.
If several units are simultaneously removed from the rack, there is a
risk that the rack could tip over.
The rack must be connected to the power supply by an authorized
specialist (electrician).
If the rack model is integrated into an installation that draws power
from an industrial power supply network with an IEC309 connector,
the power supply's fuse protection must comply with the requirements
for non-industrial power supply networks for the type A connector.
26 Operating Manual
Important Information
RX200 S3