Roland V-synth GT Supplementary Manual page 8

List of Added Tone-FX
48: Slicer
By applying successive cuts to the sound, this effect turns a
conventional sound into a sound that appears to be played
as a backing phrase. This is especially effective when applied
to sustain-type sounds.
fig.MFX-20
L in
Slicer
R in
Slicer
Parameter Value
Step 01–16 0–127
0.05–10.00 Hz,
Rate #1
note
Attack 0–127
Input Sync Sw OFF, ON
Input Sync
0–127
Threshold
LEGATO,
Mode
SLASH
Shuffle #2 0–127
Level 0–127
8
L out
R out
Description
Level at each step
Rate at which the 16-step sequence
will cycle
Speed at which the level changes
between steps
Specifies whether an input note will
cause the sequence to resume from
the first step of the sequence (ON) or
not (OFF)
Volume at which an input note will be
detected
Sets the manner in which the volume
changes as one step progresses to the
next.
LEGATO: The change in volume from
one step's level to the next remains
unaltered. If the level of a following
step is the same as the one preceding
it, there is no change in volume.
SLASH: The level is momentarily set
to 0 before progressing to the level of
the next step. This change in volume
occurs even if the level of the following
step is the same as the preceding step.
Timing of volume changes in levels for
even-numbered steps (step 2, step 4,
step 6...).
The higher the value, the later the beat
progresses.
Output level
49: VK Rotary
This type provides modified response for the rotary speaker,
with the low end boosted further.
This effect features the same specifications as the VK-7's
built-in rotary speaker.
fig.MFX-22
L in
Rotary
R in
Parameter Value
Speed #1 SLOW, FAST
Brake #2 OFF, ON
Woofer Slow
0.05–10.00 Hz
Speed
Woofer Fast
0.05–10.00 Hz
Speed
Woofer Trans Up 0–127
Woofer Trans
0–127
Down
Woofer Level 0–127
Tweeter Slow
0.05–10.00 Hz
Speed
Tweeter Fast
0.05–10.00 Hz
Speed
Tweeter Trans Up 0–127
Tweeter Trans
0–127
Down
Tweeter Level 0–127
Spread 0–10
Low Gain -15– +15 dB
High Gain -15– +15 dB
Level #3 0–127
STANDARD,
Speaker Type
STACK, CLEAN
2-Band EQ
L out
R out
2-Band EQ
Description
Rotational speed of the rotating
speaker
Switches the rotation of the rotary
speaker.
When this is turned on, the rotation
will gradually stop. When it is turned
off, the rotation will gradually resume.
Low-speed rotation speed of the
woofer
High-speed rotation speed of the
woofer
Adjusts the rate at which the woofer
rotation speeds up when the rotation
is switched from Slow to Fast.
Adjusts the rate at which the woofer
rotation speeds up when the rotation
is switched from Fast to Slow.
Volume of the woofer
Settings of the tweeter
The parameters are the same as for the
woofer.
Sets the rotary speaker stereo image.
The higher the value set, the wider the
sound is spread out.
Gain of the low range
Gain of the high range
Output Level
Type of speaker