Epson Stylus 1500 Service Manual page 129

Adjustments
7. Refer to the pattern and input a value from –12 to 12 to align both black and magenta lines (or
to bring F within 0 ± 0.035 mm), as shown in the following flowchart.
Choose " Head Gap Adj." to enter
the head gap adjustment
Select the resolution
Is the head gap OK ?
Figure 4-18. Head Gap Adjustment Flowchart
8. Press ENTER to exit the setting mode, or press SPACE to continue making settings.
The values are not permanently stored in EEPROM until the printer is turned off. Turn
off the printer immediately after adjustment.
Reset protect counter B using the adjustment program to make the printer perform the
initial ink charge operation before sending the unit back to the customer.
9. The menu below appears on the display. To end the program, press 5.
Stylus 1500 <********> Customer Data <********> 95/**/**
( Customer Data Input
( Adjustment
( END
SELECT MENU
10. Turn off the printer.
4-26
START
NO
YES
Which direction is
the pattern ?
Input +1 value and
ENTER key
Press ENTER key
NO
Are all resolutions
OK ?
YES
Press ENTER key
To main menu
CAUTION
) .... 1
) .... 2
) .... 5
F
Input -1 value and
ENTER key
EPSON Stylus 1500 Service Manual