Power Supply Status Led; Port Mode Led - HPE 5510 HI Series Installation Manual

LED mark

Power supply status LED

The switch provides two power supply slots at the rear. For each power supply, the switch provides a
power supply status LED on the front panel.
Table 25 Power supply status LED description
LED mark
PWR1
PWR2

Port mode LED

To show more information about the switch through the port status LEDs, all HPE 5510 HI switches
provides a port mode LED. The port mode LED indicates the type of information that the network port
LEDs are showing.
Table 26 Port mode LED description
LED mark
Mode
Status
Steady red
Flashing yellow (1 Hz)
Off
Status
Steady green
Steady yellow
Off
Steady green
Steady yellow
Off
Status
Steady green
Flashing green (1 Hz) (available only for HPE 5510
24G PoE+ 4SFP+ HI and HPE 5510 48G PoE+
4SFP+ HI switches)
Flashing yellow
Description
The switch has failed the POST or is faulty.
Some ports have failed to pass POST or are faulty.
The switch is powered off.
Description
A power supply is installed in power supply slot 1, and the power
supply is outputting power correctly.
A power supply is installed in power supply slot 1, but the power
supply has failed or no power is input to the power supply.
No power supply is installed in power supply slot 1.
A power supply is installed in power supply slot 2, and the power
supply is outputting power correctly.
A power supply is installed in power supply slot 2, but the power
supply has failed or no power is input to the power supply.
No power supply is installed in power supply slot 2.
65
Description
The port status LEDs are showing
port rates.
The port status LEDs are showing the
status of PoE power supply on the
ports.
The port status LEDs indicates the IRF
member ID of the switch. For
example, if the LEDs for ports 1 to 5
are steady green and the other LEDs
are off, the IRF member ID of the
switch is 5.