Hpe 5510 48G 4Sfp+ Hi - HPE 5510 HI Series Installation Manual

HPE 5510 48G 4SFP+ HI

Figure 51 HPE 5510 48G 4SFP+ HI front panel
(1) 10/100/1000Base-T autosensing Ethernet port
(3) Management Ethernet port
(5) USB mini console port
(7) USB port
(9) SFP+ port
(11) Interface card status LED (SLOT)
(13) Power supply 1 status LED (PWR1)
(15) Management Ethernet port LED
Figure 52 HPE 5510 48G 4SFP+ HI rear panel
1
(1) Grounding screw
(3) Fan tray 1
(5) Power supply 1
The HPE 5510 48G 4SFP+ HI switch comes with power supply slot 1 empty and power supply slot 2
installed with a filler panel. You can install one or two power supplies for the switch as required. In this
figure, two PSR150-A1 AC power supplies are installed in the power supply slots. For more information
about installing and removing a power supply, see
The HPE 5510 48G 4SFP+ HI switch comes with a filler panel in the interface card slot. You can select an
interface card for the switch as required. In this figure, an LSWM2SP2PM interface card is installed in the
interface card slot. For more information about installing and removing an interface card, see
"Installing/removing an interface
1 2
2 3
card."
(2) 10/100/1000Base-T autosensing Ethernet port LED
(4) Console port
(6) Port LED mode switching button
(8) System status LED (SYS)
(10) Port mode LED
(12) Power supply 2 status LED (PWR2)
(14) SFP+ port LED
4 5
(2) Interface card
(4) Fan tray 2
(6) Power supply 2
"Installing/removing a power
49
3 4 5 6
7
8
9
12
14 10
15 13 11
6
supply."