Radar Settings - Simrad R2009 User Manual

52
ETHERNET
1
2
3
* Serial 2 cable (B) is identical to Serial 1 cable (A). Therefore Serial 2 cable wires labelled as
Port 1 denote Port 3, and wires labelled as Port 2 denote Port 4. Refer "NMEA 0183 High speed serial
cable" on page 44.
Serial Output
Selection determines whether the data is output via Tx lines, and will enable editing of the
output sentences list.
Serial Output Sentences
This list allows control over which sentences need to be transmitted to other devices from
the NMEA 0183 port. Due to the limited bandwidth of NMEA 0183 it is desirable to only
enable the data that is required. The less sentences that are selected, the higher the output
rate of the enabled sentences.
Commonly used sentences are enabled by default.

Radar settings

Expanded PPI
With this option selected the radar video outside the bearing scale is also visible.
Radar installation dialog
The content of the radar Installation dialog depends on the radar antenna connected to the
system as per the table below.
All options are described in the next sections.
Option
Radar source
Radar status
Antenna setup
Adjust range offset
Adjust bearing alignment
Sector blanking
Sidelobe suppression
Tune
Software setup | R2009/R3016 User manual
HDMI NMEA2000 POWER NMEA0183 NMEA0183
A
B
10 kW 25 kW 3G
x
x
x
x
x
x
4
*
5
*
6
*
4G Halo
x x x
x x x
x x x
x
x x x
x x
x
x
x
x
x
x
x