Panasonic KX-F910BX Service Manual page 31

TX Problem
Pre-Feeding of docu-
ment?
YES
Doesn't start TX
(Doesn't start feeding?)
YES
Document goes through.
Confirm sent image on
RX side has many er-
rors?
E Increase "596:Transmit
@ level set" from -10 dBm
@ to -5 dBm or
@ some. or
Decrease "596:Trans-
E
mit level set" from -10
@
dBm to -12 dBm or
@
@ some.
OK
Change "717:Transmit
speed select " to
7200,4800 or 2400 bps.
Message on LCD
Transmit Error
NO
NO
OK
E Increase "596:Transmit
@ level set" from -10 dBm
@ to -5 dBm or some.
Ask other party, changing
RX equalizer & increas-
ing TX level.
NG
E Decrease "596:Trans-
NG
@ mit level set" from -10
@ dBm to -15 dBm or
@ some.
Ask RX party, increase a
parameter of RX error
line value to more than.
(No available)
Using auto dial to send?
Do you press START key
immediately after dialing?
NG
Decrease TX
level from -10
dBm to - 15
dBm or some.
OK
Check modern TX level.
Change "594: Oversea
DIS detection" to "Detect
at the 2nd time".
Confirm "592:CNG TX
select" to "ALL".
Ask other party, increas-
ing TX level.
| 35 |
KX-F910BX
YES
NO
NO
YES
Check other party's
machine. (Paper out,
Auto answer off...etc.)