Panasonic KX-F910BX Service Manual page 141

KX-F910BX
Bit No.
24 Extend field
25 2400 bit/s handshaking
26 Uncompressed mode
27
Error correction mode
28
Set to "0"
29 Error limiting mode
30 Reserved for G4 capability on PSTN
Unassigned
31
Extend field
32
33
Validity of bits 17,18
(0)
Bits 17,18 are valid
(1) Bits 17,18 are invalid
Recording width capability 1216 picture elements
34
along scan line length of 151 mm } 1%
Recording width capability 864 picture elements
35
along scan line length of 107 mm } 1%
Recording width capability 1728 picture elements
36
along scan line length of 151 mm } 1%
Recording width capability 1728 picture elements
37
along scan line length of 107 mm } 1%
Reserved for future recording width capability
38
Reserved for future recording width capability
39
40 Extend field
41 Semi super time / mm
Semi super time / inch
42
Super time
43
inch
44
45 mm
46 MSC/SF
Select polling
47
48 EXT
Note 1 - Standard facsimile units conforming to T.2 must have the following capability : Index of cooperation (IOC)=264.
Note 2 - Standard facsimile units conforming to T.3 must have the following capability : Index of cooperation (IOC)=264.
Note 1 - Standard facsimile units conforming to T.4 must have the following capability : Paper length=297 mm.
Signal
Training 1
TCF
(Training Check)
CFR
(Confirmation to Receive)
Training 2
DIS/DTC
Identification Signal Format
X0100001
|150 |
Standard setting
1 Extend field
0
2400 bit/s handshaking
0
Uncompressed mode
0 Error correction mode
Frame size 0 = 256 octets
0
Error limiting mode
0
0 Reserved for G4 capability on PSTN
0
Extend field
1
Recording width
0 Recording width indicated by bits 17,18
Recording width indicated by this field bit
information
0
Middle 1216 elements of 1728 picture
elements
0
Middle 864 elements of 1728 picture
elements
0
Invalid
0
Invalid
0
0
1 Extend field
1
0
0
0
1
0
0
0
Fixed pattern is transmitted to receiving side at speed
(2400 to 9600 bps) designated by DCS, and the receiving side
optimizes the automatic equalizer, etc., according to this signal.
Sends 0 continuously for 1.5 seconds at the same speed as the
training signal.
Notifies sending side that TCF has been properly received. If
TCF is not properly received, FTT (Failure To Train) X0100010
is relayed to sender. Sender then reduces transmission speed
by one stage and initiates training once again.
Used for reconfirmation of receiving side the same as training 1.
DCS
1 = 64 octets
Function