Table of Contents
Advertisement
SC CODE TABLE
SC
Item
Detection Conditions
No.
SC726 Sorter:
- Timing & Condition -
End release
The bin end open or close
motor error
sensor does not activates
within the timing
programmed.
When this error detected
twice, this SC code is
displayed.
SC727 Grip shift
- Timing & Condition -
motor error
The grip H.P. sensor does
not activates within the
timing programmed.
When this error detected
twice, this SC code is
displayed.
SC731 Sorter:
- Timing & Condition -
Staple unit
The staple unit H.P. sensor
motor error
does not activates within the
timing programmed.
When this error detected
twice, this SC code is
displayed.
SC741 LCT:
- Timing & Condition -
·
Main motor
LCT main motor speed is
error
out of range for more
than 0.5 seconds during
rotation.
Related
Possible Causes
SC
·
Poor connection of
connectors.
·
Defective bin end
open or close
sensor
·
Defective end
release motor
·
Defective main
board
·
Poor connection of
connectors.
·
Defective grip H.P.
sensor
·
Defective grip shift
motor
·
Defective main
board
·
Poor connection of
connectors.
·
Defective staple
unit H.P. sensor
·
Defective grip shift
motor
·
Defective main
board
·
Poor connection of
connectors
·
Defective LCT
main motor
·
Defective LCT
main board
34
Troubleshooting Procedure
1. Check if the connectors of the bin end open and close
sensors and end release motor are properly connected.
2. Replace the bin end open or close sensor. (Input
check: SP 5-803-126/127)
3. Replace the end release motor. (Output check: SP 5-
804-125)
4. Replace the main board.
1. Check if the connectors of the grip H.P. sensor and grip
shift motor are properly connected.
2. Replace the grip H.P. sensor. (Input check: SP 5-803-
129)
3. Replace the grip shift motor. (Output check: SP 5-804-
126)
4. Replace the main board.
1. Check if the connectors of the staple unit H.P. sensor
and/or staple unit motor are properly connected.
2. Replace the staple unit motor H.P. sensor. (Input
check: SP 5-803-130)
3. Replace the staple unit motor. (Output check: SP 5-
804-128)
4. Replace the main board.
1. Check if the connector is properly connected.
2. Replace the LCT main motor.
30 March, 1999
Type
D
D
D
D
Advertisement
Table of Contents
