2: Reset The Mixer - SoundCraft Ui24R User Manual

Ui24R User Manual
SOFTWARE > RESET THE MIXER
There are two levels of reset for the Ui mixer. The first will reset network settings in the event that you
are unable to connect. The second (uses a fullreset.txt file on a USB memory stick in conjunction with
the reset button. This will fully reset the unit back to its factory firmware and default settings.
Networking Reset
Reset Networking and Admin password if you have forgotten the admin password or if you are no longer
able to connect to the Ui.
Use a paper clip (or similar) to hold down the recessed reset button (side panel) down for approximately
10 seconds while you power on the unit. This will initialise the Ui's networking and admin password to the
default state.
Full Reset
This method removes all updates you may have performed on the mixer and returns the unit to its
default factory shipping firmware and state. All settings, snapshots, users, profiles and shows will be lost.
Please ensure you have saved/backed up any shows before resetting your Ui.
1) Create a test file named fullreset.txt (no contents necessary) and copy to a USB stick
2) Insert the USB stick into one of the Ui's USB ports.
3) Use a slim, long object to hold the reset button down for approximately 10 seconds while you power on
the unit.
4) The Ui will recognise the fullreset.txt file on the USB stick and perform a full factory reset.
5) You must power cycle the unit and reconnect the client device. Power off for at least 10-15 seconds be-
fore powering back on.
Note: A flick of the power off/on will almost always fail to boot properly, and can get stuck (with continuous
flashing blue Wi-Fi LED). Make sure to power off, wait 10-15 seconds, then power on. The blue Wi-Fi LED
will pulse/flash for around 10-15 seconds then remain on.

3.0.2: RESET THE MIXER

3.0.2: RESET THE MIXER