Grandstream Networks GAC2500 User Manual page 33

CONNECTING TO NETWORK AND DEVICES
The GAC2500 supports a variety of network connections (Ethernet, Wi-Fi) and device connections, you
can configure on GAC2500 or log in the GAC2500 web UI to configure. For more information about using
web UI, please refer to the GAC2500 Administration Guide in www.grandstream.com.
NETWORK
Network connection has a variety of ways, one is wired connection via the cables, and the other way is to
connect via Wi-Fi.
ETHERNET
If the user would like to use Ethernet connection for network access, please plug the Ethernet cable to the
LAN port on the back of the GAC2500. Ethernet connection is turned on as DHCP by default.
To configure Ethernet settings on GAC2500:
1. Plug the Ethernet cable into the LAN port on the back of the GAC2500.
2. Go to LCD menu->Settings->Network->Ethernet->IPv4 Settings.
3. Tap on "Address Type" to select DHCP, Static IP or PPPoE as the address type.
 For DHCP, save the setting and the GAC2500 should be able to get IP address from the DHCP
server in the network.
 For static IP, enter IP Address, Subnet Mask, Default Gateway, DNS Server and Alternative DNS
server for the GAC2500 to correctly connect to the network.
 For PPPoE, enter PPPoE account ID and password so the GAC2500 can get IP address from the
PPPoE server.
WI-FI
Wi-Fi is supported and built-in on the GAC2500. On the LCD display, go to Settings->Network-> Wi-Fi to
turn on and configure Wi-Fi.
Firmware Version 1.0.1.x GVC2500 User Guide Page 32 of 88