Prepare Unit For Use; Automatic Chemical Feed - Sandia 80-5000 Operation And Maintenance Manual

4.0 Prepare Unit for Use

DO NOT USE ON WET SURFACES. DO NOT EXPOSE TO RAIN. STORE
INDOORS.
• All hard surface extractors, no matter what the time of year, are shipped with
antifreeze in the solution lines. Prior to first use, fill the solution tank with one quart
of warm water. Attach the hose and using a hand tool or wand, flush out the system by
spraying the one quart of water through the pump.
• Attach the vacuum hose and the brass quick disconnect.
• Fill the solution tank with warm water (less than 100 degrees Fahrenheit). Fill to
approximately 4 inches from the top. Pre-spray and agitate the surface with detergent
made for floor cleaning or upholstery. Use only warm water to extract the pre-spray
from the surface.
• Be sure to replace any filters back into the machine prior to use.
• Do not use citric acid, butyl glycol or harsh degreasers inside the machine.
4.1

Automatic Chemical Feed

WARNING: THE HARD SURFACE EXTRACTOR IS DESIGNED FOR US
WITH WATER-BASED CLEANING SOLUTIONS, SUCH AS LOW-FOAMING
DETERGENTS OR ACID RINSES. Never use dry solvent solutions. The use of
dry solvents in your extractor will void the warranty.
Chemical Metering: the Hard Surface Extractor is equipped with an automatic
water fill/chemical feed metering system. As the solution tank fills with water, cleaning
concentrate is drawn into the solution tank at a designated rate, via metering tip. A
complete set of metering tips are included.
Metering Tip Replacement: to adjust the amount of cleaning concentrate being
drawn, simply remove the plastic supply tube from the chemical feed metering valve
(Figure 1). Continues on the next page.
(8) 1200 PSI Hard Surface Extractor
11.0 Base with Vacuum Components Parts List
Drawing No. Item No.
39 10-0848-B
40 80-0003-A
41 SN-12-MFLD
42 10-0836
43 10-0807
44 10-0820
45 10-0419-A
46 10-0822
47 10-0808
48 10-0816
49 10-1030-S2
50 10-0204
51 10-0811
52 10-0833-L
53 T-A001
54 10-0810
55 80-0116
56 10-0155
57 10-1030-S3
Description
1-1/2" 90 Degree ABS Street Elbow
1-1/2" Black Lined Gray Hose
Extractor Motor Manifold
19" Axle for Extractor
Wheel for Extractor
End Cap for Extractor Axel
Screw for Extractor Hatch
Exhaust Grate
Caster for Extractor
1/4-20 - 1/2" Hex Caster Bolt
2-Stage Extractor Motor Gasket
Motor Mount Back-Up Washer
2-Stage Extractor Motor
Manifolt Bolt 10-32 x 1/4" Hex Screw
Cooling Duct
3-Stage Extractor Motor
Spacer for Extractor Motors
Straight Hose Cuff
3-Stage Extractor Motor Gasket
1200 PSI Hard Surface Extractor (33)
Quantity
4
2
2
1
2
2
6
3
2
8
1
6
1
6
2
1
6
1
1