Install Any Internal Options - Digital Equipment Server 3100 series Installation Manual

3

Install any internal options

If you have options to install, install them now.
1. Unlock the door and front bezel.
2. Open the front bezel and loosen the two side panel
thumbscrews.
3. Remove the side panel.
4. Install the options.
Refer to the following chapters in the System Reference
manual for detailed information.
Server Software and Utilities
Pentium Pro Processor Upgrades
Pentium II Processor Upgrades
Installing Additional Memory (SIMMs)
Installing Additional Memory (DIMMs)
Installing Disk and Tape Drives
Connecting SCSI and RAID Adapters
Installation Guide
Also, refer to the documentation that came with the option
kit for specific installation instructions.
CAUTION
Before touching any circuit board or component,
wear an anti-static wrist strap, properly grounded
to the server chassis, or touch the metal frame to
discharge any static electricity.
NOTE
ISA cards should be installed after you run the System
Configuration Utility (SCU) in Step 7 or 8, since the SCU
will list IRQs already used.
If you plan to use Quick Launch to install your Network
Operating System, your server must meet the following
minimum requirements to proceed with the server in-
stallation.
16 MB of RAM
SVGA monitor
540 MB minimum hard disk drive
Two or three button mouse
CD-ROM drive with boot capability attached to the
bootable SCSI controller
Keyboard
5