Table of Contents Overview The Dogtra E-Fence 3500 system gives you the ability to allow Overview ..............Main Features of the E-Fence 3500 ........Dogtra’s containment system contains your dog without the use of conventional fencing that can be chewed through, jumped Safety Features ............
Manual · 2-hour rapid charge Lithium Polymer batteries Safety Features Transmitter Ground Wire Receiver/Collar · Dogtra’s E-Fence 3500 system collars use state-of-the-art Power Adaptor Charger (5-volt 1A) (green) microcomputer technology. The receiver/collar has an (24-volt 500mA) automatic control that limits the stimulation to eight seconds.
On/Off & Function Selection Switch Description of Transmitter Parts The On/Off & function selection switch has three functions. When the toggle switch is in the up On/Off position, the unit will give the Boundary Wire Indicator Light Continuity Light dog a pager/vibration followed by stimulation correction.
Page 5
Boundary Wire Continuity Light Power Jack When the wires are connected Plug the 120-volt adaptor into a properly, the boundary wire 120-volt wall outlet and insert continuity light will be on. the adaptor plug into the power In the event that the E-Fence jack of the transmitter.
In order to maintain full use of the batteries in the collar, please turn off the receiver/ collar when your E-Fence 3500 system is not being utilized. Receiver Indicator Light (LED) receiver/collar will illuminate for approximately 1 second to indicate that the power is on.
Page 7
If the collar is too loose, electrical contact will be and let air dry. inconsistent and your corrections will be inconsistent also. Dogtra uses surgical stainless steel contact points and Anti- Adaptor microbial plastic to protect the dog’s skin.
Charging the Receiver/Collar Points Dogtra uses Lithium-Polymer batteries. The Dogtra E-Fence 3500 comes equipped with standard 5/8” contact 1. Charge the unit before using points that can be extended to 3/4” contact points, for use with dogs with longer coats.
Testing Your Dogtra E-Fence 3500 Prior Installation to Installation 1. To ensure that your E-Fence 3500 system is working properly, connect the power adaptor into the transmitter power jack and then plug the power adaptor into a household outlet. Switch the stimulation knob to Pager + Stimulation, or Pager Only.
Page 10
Common Boundary Designs CAUTION Before you install your E-Fence 3500 wire, contact the utility company to mark the utility lines on your property before you begin digging. Be sure to test your wire layout above ground before permanent installation begins.
The E-Fence 3500 boundary wire does not have to be buried to with a masonry blade for cutting the pavement. operate. For protective measures we highly recommend the wire be buried about 3-4 inches underground.
6 feet parallel to DO NOT The waterproof splices included electrical, telephone, cable TV or other buried wires. in the E-Fence 3500 system are run the e-fence boundary wire of one section within DO NOT designed to provide a sealed 10 feet of another section of e-fence wire or the signal connection between the wires.
Splice the two ends of the The following items may be purchased separately. To purchase twisted wire to each of the two accessories, please visit Dogtra's online store at www.dogtra.com ends of the fence wire. Drill a or call customer service at 1-888-811-9111.
Connecting a Lightning Surge Protector Troubleshooting Guide 1. Dog Does Not Respond to Stimulation Transmitter Adaptor - Trim the dog’s hair or use longer contact points to make better Transmitter skin contact. - Recharge the battery in the receiver/collar. - Adjust the stimulation intensity level. 2.
General Maintenance Tips Your system requires very little maintenance. The receiver/collar Choke and an AM radio tuned to for the E-Fence 3500 system is fully waterproof. To remove dirt, AM530. Go to the wall mount simply wipe with soap and water.
Pet Series, eF-3000 Gold, E-Fence 3500, RR Deluxe, YS200, YS300, YS500, and responsibility. Dogtra is not responsible for units damaged or lost in transition to Dogtra. Dogtra is not responsible for loss of training time or inconvenience while the unit is in for Parts, Labor, and Accessories.