Chevrolet trailblazer Handbook page 35

10460390) - 2017 - crc - 6/15/16
34 Keys, Doors, and Windows
Operate the switch for each
respective window by pushing to
open or pulling to close. The switch
for the driver's window has a light
which signals, through illumination,
the operation readiness.
Pressure Relief
To reduce the front doors closing
effort, when any of the front doors
are opened it`s respective window
will automatically lower some
centimeters to reduce the closing
effort.
Express Power Window
Automated Operation
To fully open the window
automatically, press the switch fully
down. To fully close the window
automatically, pull the switch fully
up. In automatic operation, the
window will fully open or close even
if you let go of the switch.
To stop the window at the desired
position while the window is in
automatic operation, pull up or
press down and release the switch
to the same direction of the
movement.
Window Electronic
Programming
Programming the power windows
may be necessary if the 12-volt
battery has been disconnected or
discharged. To program the window:
Whenever you first turned on or
when turned off the battery of the
vehicle, the Intelligent System
Power Windows should be
programmed. This schedule should
be made in the conjunction of the
driver's door switch, follow the steps
below:
1. Turn on the ignition (without
running the engine)
2. Press the power window switch
in the direction "up" to its limit
and hold for 2 seconds
3. Press the power window switch
in the direction "down" for
about 2 seconds. When you
drop it, the window
automatically descend to its
limit
4. Repeat for all windows of the
vehicle
Obs .: In case of battery
replacement, window regulator
replacement or changing position of
the modules, you will need to
recalibrate it. To do this, turn the
ignition off and repeat the procedure
described above.