5.9
If paint is used
RoHS required
WEEE require
If new painting type need to implement, refer to UN-D 1235.
5.10 Plastic mold tooling
Tooling to be designed to minimize cosmetic defects induced by molding process (sink, blush,
weld lines, gate marks, ejector marks, etc.). Refer to "TYV61-90007".
Painting to cover up cosmetic defects due to molding is strongly discouraged.
China RoHS mark requested.
5.11 Plastics flammability
All Plastics to be Flame Retardant UL 94-HB or Better.
Base / Pedestal to be Flame Retardant UL 94-HB.
All major plastic parts (bezel, back cover) need to be molded from same resin.
Plastic resin type selection should be referred to "plastic-Philips Pool monitor".
5.12 Texture/Glossing of housing
The texture area and texture no should follow Philips make-up sheet.
The exterior surfaces shall have a uniform texture.
Philips must approve the mold texturing.
Detail document for texture refer to "UN-D249", "UN-D 600".
Glossy surface > = 80 gloss units
5.13 Tilt and swivel base
Tilt angle
Swivel angle : nil
High Adjustment : nil
Portrait Display : nil
5.14 Kensington Lock
Must meet Kensington_slot.spec "TYE-M0004".
MMD request metal plate in Kensington hole.
Rev :
0.1
2011/07/12
Date :
:
-5 +2/- 0 (forward)
+20 + 0/- 3 (backward)
M4 241S4 / 241B4
Type
:
PHILIPS
Brand :
241B4LP LCD
24" Wide 16:9 LCD Monitor
15 of 20
Page :
71