Epson L365 Service Manual page 47

L365/L366,L360/L362,L310/L312,L220/L222,L130/L132 Series
Bottom Cover / Left Cover / Right Cover / Cover Joint
Left Cover
Bottom Cover
3 5 6 4
1
C.B.P-TITE SCREW 3x6 F/ZN-3C (4 ± 1
Be careful about how to place the Ink Supply Tank Assy in order to prevent printing failure from occurring. (See
.)
Disassembling (p25)"
The figures above indicate the hooks and ribs that secure the parts.
Remove the exterior parts of the Ink Supply Tank Assy in the following order.
1. Remove the screws (x6) of the Bottom Cover, and remove the Bottom Cover.
2. Remove the Left Cover and Right Cover.
3. Remove the Cover Joint.
Tighten the screws in the order indicated in the figure above.
Disassembly/Reassembly
Cover Joint
Ink Supply Tank Assy
Hook
Rib
2
"2.1.5Checks and Precautions before
Detailed Disassembly/Reassembly Procedure for each Part/Unit
0.5 mm or less
When connecting the Ink Supply Tank Tube to the Ink Supply Tank, confirm the color indicated on the film of the Ink Supply Tank, and take
care not to connect them with wrong joints.
When connecting the Ink Supply Tank Tube to the Ink Supply Tank, insert the tubes to the full and make sure the gaps between the end of tubes
and the tank are 0.5 mm long or less.
Right Cover
Joint
Ink Supply Tube
Ink Supply Tube Guide 2nd
When attaching the Joint, align the cutout of the Joint with the rib of the Ink Supply Tube Guide 2nd.
Make sure the gaps between the end of Ink Supply Tank Tubes or Ink Supply Tubes and the Joint are 0.5 mm long or less.
Ink Supply Tank Tube Assy
Joint
Black 387 ± 1 mm
Yellow 358 ± 1 mm
Magenta 330 ± 1 mm
Cyan 311 ± 1 mm
265 ± 1 mm
Ink Supply Tank Ink Supply Tank Tube
Ink Supply
Tank Tube
Bk Y
Joint
Ink Supply Tube
Joint
Rib
Revision A
Cober/Guide Tube Tank
M C
0.5 mm or less
Joint
0.5 mm or less
Ink Supply Tank Tube
Cutout
47
Confidential