Epson L365 Service Manual page 69

L365/L366,L360/L362,L310/L312,L220/L222,L130/L132 Series
PF Roller
Figure 4-10. Lubrication of the PF Roller
Main Frame Assy
CR Unit
Frame Base
Figure 4-13. Lubrication of the Main Frame Assy
Maintenance
<Part supply as ASP>
Yes
<Lubrication status when
supplied as ASP>
Not lubricated
<Lubrication Point>
Contact points (x3 on the
shaft) on the PF Roller
with the Frame Base
<Type>
G-71
<Application Amount>
On each contact point
Frame Base around the shaft
(appropriate amount)
<Remarks>
Apply with injector.
Lubricate before
attaching the part.
Application Point
<Part supply as ASP>
None
Main Frame Assy
<Lubrication status when
supplied as ASP>
---
<Lubrication Point>
1. Contact point (x1) on
the upper side of the
Main Frame Assy with
the CR Unit
2. Contact points (x4) on
the lower side of the
Main Frame Assy with
the CR Unit
<Type>
G-71
<Application Amount>
Appropriate amount
<Remarks>
Apply with injector.
Application Point
CR Driven Pulley Holder
1. Application Point
2. Application Point
Figure 4-11. Lubrication of the CR Driven Pulley Assy
Spread grease with brush.
Lubrication Points and Instructions
<Part supply as ASP>
None
CR Driven Pulley
<Lubrication status when
supplied as ASP>
---
<Lubrication Point>
1. On the bearings (x2) of the
CR Driven Pulley on the
CR Driven Pulley Holder
2. Contact points (x6) on
the groove of the CR
Driven Pulley Holder
with the Main Frame
<Type>
G-71
<Application Amount>
Appropriate amount
<Remarks>
Apply with injector.
Check the lubrication
condition and apply
grease if necessary.
CR Driven Pulley Shaft
Figure 4-12. Lubrication of the CR Driven Pulley/
Guide rail
Scanner Housing Lower
Figure 4-14. Lubrication of the Scanner Housing Lower
Revision A
<Part supply as ASP>
None
<Lubrication status when
supplied as ASP>
---
<Lubrication Point>
1. Shaft hole of the Driven
Pulley.
2. CR Driven Pulley Shaft
<Type>
G-71
<Application Amount>
Appropriate amount
<Remarks>
Apply with injector.
1. Application Point
2. Application Point
CR Driven Pulley Shaft
<Part supply as ASP>
Supplied as the Scanner
Unit
<Lubrication status when
supplied as ASP>
Lubricated
<Lubrication Point>
Guide rail of the Scanner
Housing Lower
<Type>
G-45
<Application Amount>
0.03 g x 3 points
<Remarks>
After applying with
injector, spread it with
brush in the direction of the
arrow.
Application Point
69
Confidential