Epson L365 Service Manual page 42

L365/L366,L360/L362,L310/L312,L220/L222,L130/L132 Series
Panel Unit (L365/L366 Series)
Frame Base (left)
Rail section
Panel Unit
When installing the Panel Unit, follow the procedure below.
1. Route the Panel FFC and grounding wire through the holes of the Frame Base.
2. Insert the dowels (x2) of the Panel Stand into the grooves on both sides of the Frame Base from the sections indicated in the arrows shown above.
3. Insert the dowels (x2) of the Panel Unit into the holes (x2) of the Frame Base, and secure the Panel Unit to the Frame Base.
Panel Unit (L360/L362,L220/L222 Series)
Frame Base (left)
Tab
Push
Panel Unit
Hole of Frame Base
Rail section
C.B.P-TITE SCREW 3x10 F/ZN-3C (6 ± 1 kgf·cm)
When removing the Panel Unit, follow the procedure below.
1. Remove the two screws that secure the Panel Unit.
2. Pull out the shaft on the both ends of the Panel Unit from the holes of the Frame Base.
3. While pressing the right and left tabs on the rear of the Panel Unit inward, disengage the two dowels and two ribs of the Panel Unit from the rail
of the Frame Base.
4. Pull out the Panel FFC through the hole of the Frame Base, and remove the Panel Unit.
Tighten the screws in the order indicated in the figure above.
Disassembly/Reassembly
Frame Base (right)
Panel Unit
Rail section
Panel Stand
(p 50)
Panel Unit
Frame Base (right)
Hole
Shaft
Rib
Rail section
Detailed Disassembly/Reassembly Procedure for each Part/Unit
Inside Panel Unit
Panel Housing
Upper Assy
Hole
Be careful not to damage the hooks (x2) of the Panel Housing Upper Assy when releasing them.
Dowel
When removing the Panel Housing Lower Assy, follow the procedure below.
1. Remove the screws (x3) on the back of the Panel Unit.
2. Widen the upper side of the Panel Unit slightly to release the hook of the Panel Housing Lower Assy.
3. Release the hooks (x2) of the Panel Housing Upper Assy one by one, and remove the Panel Housing Lower Assy.
Inside Panel Unit
Tab
Push
Panel Housing
Upper Assy
Be careful not to damage the hooks (x2) of the Panel Housing Lower Assy when releasing them.
When removing the Panel Housing Lower Assy, follow the procedure below.
1. Remove the screws (x1) on the back of the Panel Unit.
2. Disengage the two hooks of the Panel Housing Upper Assy one by one.
3. Disengage the two hooks of the Panel Housing Lower Assy, and remove the assy.
Panel Housing Lower Assy (L365/L366 Series)
Panel Housing
Lower Assy
Hook
Panel Unit
Panel Housing Lower Assy (L360/L362,L220/L222 Series)
Back
Panel Housing
Lower Assy
Hook
Panel Unit
Revision A
Back
C.B.P-TITE SCREW 3x10 F/ZN-3C (6 ± 1 kgf·cm)
C.B.P-TITE SCREW 3x10 F/ZN-3C (6 ± 1 kgf·cm)
42
Confidential