Motorola AP-6511 Installation Manual page 15

12 AP-6511 Access Point Installation Guide
5. Remove the blank plug before installing the RJ11 into the snap-in port.
6. Install the RJ11 (keystone style) connector into the AP-6511's snap-in port.
7. If using the optional second RJ-45 Ethernet port (utilizing a pass through keystone cable),
ensure the following steps are completed:
a. Bend the cable into a "U" shape so the mini pin connector and the RJ-45 keystone cable
are in close proximity to one another.
b. Install the mini pin connector into the pin socket on the back of the AP-6511. The
connector is keyed and can only be installed one way. Ensure the mini pin connector is
connected securely.
c. Remove the blank plug from the keystone hole by gently pushing it out from the back.
d. Orient the RJ-45 keystone connector so the flexible keystone tab is away from the mini
pin connector. Tip the keystone RJ-45 while installing in the keystone opening so the
solid locking tabs engage, then rotate the RJ-45 forward until the tab snaps securely.
8. Install the RJ-45 double plug uplink jumper into the UP1/POE jack and connect it into the
RJ-45 Ethernet connector.
To PBX
RJ45 connector