SERVICE MANUAL
10. Key S/N into the blank space beside Bar Code, then press "Enter" button on keyboard to
begin programming. (Showed as Figure 7)
S/N
11
After finishing the above actions, "VGA Success and DFP Success" will be showed on the
screen (Showed as Figure 8). Then connect MP1400 with PC.
successful
signal
12. Press "Menu" in MP1400 and choose the S/N in the Management to check if the S/N is the
same as the one you key in.
13. If S/N is the same, it is successfully finished. If not, please repeat above procedure 9 ~12
again.
Martin 9-4
(Figure 7)
(Figure 8)