Balluff BES M30EP-PFC12F-S04G-D12 User Manual page 30

BES M/Q...-D12 Inductive Safety Sensors
Delayed switching of the Signal LED
BES057A:
Undamping < 2 s:
0
> 3 s
BES057C:
Undamping < 2 s:
0
BES0577:
Undamping < 2 s:
0
Close zone
1
Release zone
2
Figure 11
30
If the damping element was removed from
the sensor for more than approx. 2 sec.
(> 30 mm), the yellow Signal LED comes on
when damping in the release zone with a
delay of approx. 3 sec.
This is also the case if the damping element
30 mm
is located in the release zone when power is
turned on.
Signal
Power
If the damping element was removed from
the sensor for more than approx. 2 sec.
(> 45 mm), the yellow Signal LED comes on
when damping in the release zone with a
delay of approx. 3 sec.
This is also the case if the damping element
45
mm
> 3 s
is located in the release zone when power is
turned on.
Signal
Power
If the damping element was removed from
the sensor for more than approx. 2 sec.
(> 30 mm), the yellow Signal LED comes on
when damping in the release zone with a
delay of approx. 3 sec.
This is also the case if the damping element
30
mm
> 3 s is located in the release zone when power is
turned on.
Signal
Power
Delayed switching