BES M/Q...-D12 Inductive Safety Sensors
–
The device may be installed, connected and put into service only
by a person trained in safety technology and electronics.
–
The relevant technical standards must be considered as part of
the respective application.
–
Observe the requirements of EN 60204 when installing.
–
If the device malfunctions, contact the manufacturer. Opening of
and tampering with the device are not permitted.
–
Disconnect the device from power before working on it. If
appropriate also turn off independently powered relay circuits.
–
Perform a complete function test after installation, maintenance
or repair.
–
Use the device only in specified ambient conditions (see Section
Technical Data on page 36). Contact the manufacturer for any
special ambient conditions.
–
Use only within the specified application description.
–
Safety requirements for the application
–
The safety requirements for the respective application must
agree with the requirements laid out here.
www.balluff.com
15