Display Message List - Yamaha AW2816 Service Manual

AW2816

DISPLAY MESSAGE LIST

Messages
AUTOMIX DISABLED.
AUTOMIX MEMORY FULL!
AUTOMIX NOT RUNNING.
AUTOMIX REC ABORTED.
AUTOMIX RECORDING.
AUTOMIX RUNNING.
BULK: BYTE COUNT MISMATCH!
BULK: CHECKSUM MISMATCH!
BULK: MEMORY PROTECTED!
CANNOT ASSIGN DIGITAL-ST-IN.
CANNOT CHANGE THE MUTE
CANNOT PLAY THIS PAGE
CANNOT RECALL AUTOMIX
CANNOT REDO
CANNOT SET MARK
CANNOT UNDO
CD PLAY MODE NOW.
DIFFERENT TC FRAME TYPE
DIGITAL-ST-IN REC PROHIBIT.
DIGITAL-ST-IN SYNC ERROR!
DIN TO STEREO BUS REFUSE.
DISK BUSY
DRIVE NOT READY
EFF1 INSERT RELEASED
EFF2 INSERT RELEASED
FOR EFFECT2 ONLY.
IN/OUT POINTS TOO CLOSE
INT.EFF NOW SELECTED AUX.
LOW BATTERY!!
78
Automix is not enabled, and cannot be recorded.
Automix memory has no free area.
Automix has been stopped, so recording is not possible. Pause the
recorder, and then playback.
Automix recording was stopped, and the data was discarded.
The operation cannot be executed since automix is being recorded.
The operation cannot be executed since automix is being recorded or
played.
The data length specified within the received system exclusive data
did not match the length of the data that was actually received.
The check sum of the received system exclusive is incorrect.
The scene memory you attempted to receive is protected.
DIGITAL STEREO IN cannot be assigned to the stereo bus cascade.
Muting cannot be defeated since this would exceed the number of
simultaneously playable tracks.
Playback is not possible in this page.
Recall is not possible, since automix data has not been stored.
Redo (re-execution of an operation) is not possible.
It is not possible to specify a mark at an already-specified position.
Undo (cancellation of an operation) is not possible.
Since the AW2816 is in CD Play mode, this operation is not possible.
MTC of a different frame type than the internal setting is being
received.
Recording is prohibited for the signal being input from DIGITAL STE-
REO IN.
The signal being input from DIGITAL STEREO IN is not synchronized
to the word clock master.
Since the signal was interrupted, cascading from DIGITAL STEREO IN
to the stereo bus has been defeated.
The reading speed of the internal hard disk is not fast enough, or the
reading speed has slowed down because the recorded data has
become fragmented.
The drive is not ready.
Effect 1 has been released from insertion because a patch library was
recalled.
Effect 2 has been released from insertion because a patch library was
recalled.
The selected effect program can be used only with effect 2.
The auto punch-in/out interval is too short. It cannot be set less than
approximately 100 msec.
The internal effect is connected to the AUX send, and cannot be
inserted.
The internal battery is running down.