JVC UX-HB4 Service Manual page 19

3.1.12 Removing the DAB module board
(See Fig.29,30)
• Prior to performing the following procedure, remove the front
panel assembly.
• Reference; It is not necessary to remove the main board.
(1) From the left side of the body, remove the two screws K'
attaching the DAB module board.
(2) Disconnect the wire from connector
ule board.
(3) Disconnect the DAB module board from connector JK10 on
the main board by pulling out. The holder comes off with
the DAB module board.
(4) Release the four joints g of the holder and remove the DAB
module board.
CN3 on the DAB mod-
CD mechanism assembly
K'
Fig.29
DAB module board
CN3
Front panel assembly
Joint g
DAB module board
Joint g
Holder
Fig.30
Front panel assembly
Main board
CD mechanism assembly
JK10
Main board
(No.MB330)1-19