NS system Tango-B series User Manual page 7

CAUTION
▶
Care must be taken during the transportation. Falling to the foot may cause the injury.
▶
Only the voltage specified in the User's Manual should be applied to each terminal.
Otherwise, a burst, damage, etc. may occur.
▶
Connect the terminals correctly to prevent a burst, damage, etc.
▶
During power-on or some time after power-off, do not touch the servo amplifier fins, regenerative
brake resistor, servo motor. Their temperatures may be high and you may get burnt.
CAUTION
▶
Do not carry the motor by the cables, shaft or encoder.
▶
Do not hold the cover to transport the servo amplifier. The servo amplifier may drop.
▶
Transport the products correctly according to their weights.
▶
Do not climb or stand on servo equipment. Do not put heavy objects on equipment.
CAUTION
▶
Install the servo amplifier in a load-bearing place in accordance with the User's Manual.
▶
The servo amplifier and motor must be installed in the specified direction.
▶
Leave specified clearance between the servo amplifier and control enclosure walls or other
equipment.
▶
Provide adequate protection to prevent screws and other conductive matter, oil and other
combustible matter from entering the servo amplifier.
▶
Securely attach the servo motor to the machine. if attach insecurely, the servo motor may come off
during operation.
▶
For safety of personnel, always cover rotating and moving parts.
▶
Never hit the servo motor or shaft, especially when coupling the servo motor to the machine.
The encoder may become faulty.
▶
The servo motor with reduction gear must be installed in the specified direction to prevent
from oil leakage.
▶
Do not subject the servo motor shaft to more than the permissible load. Otherwise, the shaft may
break
▶
Use the servo motor and amplifier under the following environmental conditions.
Environment
Ambient operate
storage
Temperature
Ambient operate 80%RH or less (non-condensing)
storage 90%RH or less (non-condensing)
Humidity
Ambience
Altitude
Vibration
☞ To prevent injury, note the following:
☞ Transportation
☞ Installation and Storage
Servo Amplifier
0 ℃ ～ +55 (non-freezing) ℃
-20 ℃ ～ +65 ((non-freezing) ℃
free from corrosive gas, flammable gas, oil mist, dust and dirt
0.6G or less
0 ℃ ～
-15
80%RH or less (non-condensing)
90%RH or less (non-condensing)
Indoor(no direct sunlight)
Max. 1000m above sea level
Servo Motor
+40 ((non-freezing) ℃
℃ ～ +70 ((non-freezing) ℃
2.5G or less