Advertisement
Oven Controls
Setting Self Clean
Self Clean allows a user to select a 2, 3, or 4 hour self clean
cycle.
To set a Self Clean cycle immediately:
1.
Be sure the oven in empty and all oven racks are removed.
Be sure the oven door is completely closed.
2. Press Self Clean once. The display will show
3. Press
or
. The display will show 3:00 to indicate
the default 3 hour clean time is selected. To change to a 2
or a 4 hour clean time press
or 4:00 appears in the display then release the arrow key.
4. After selecting the clean time Self Clean will activate. The
DOOR LOCKED indicator light will light and CLn will
appear in the display. Do not attempt to open the oven
door when the DOOR LOCKED indicator light is flashing
and while self clean is active. Doing so could damage the
door locking mechanism. Allow about 15 seconds for the
oven door to completely lock.
5. Once the oven door locks, the DOOR LOCKED indicator
light will glow steady.
Use caution when opening the oven door after
self cleaning. The oven may still be very hot and can cause
burns. To avoid possible burns stand to the side of the oven when
opening the oven door to allow hot air or steam to escape.
When Self Clean is finished:
1.
Once the oven has cooled down (about 1 hour) and the
DOOR LOCKED indicator light has turned off the oven door
may be opened.
2. When the oven interior has completely cooled, wipe away
any residue or powdered ash with a damp cloth or paper
towel.
Important note:
If Self Clean is active and a power failure occurs, the oven may
not have thoroughly cleaned. This would depend on how much
cleaning time had elapsed before the power failure. If needed
after power is restored, set Self Clean again.
— —
.
; until 2:00 appears
Important notes:
•
The kitchen area should be well ventilated using an open
window, ventilation fan or exhaust hood during the 1st self
clean cycle. This will help eliminate the normal odors asso-
ciated with the 1st self clean cycle.
•
Do not attempt to open the oven door when the DOOR
LOCKED indicator light is flashing. Allow about 15 seconds
for the motorized door latch mechanism to completely lock
or unlock the oven door.
•
When the clean time finishes the oven door will remain
locked until the range has cooled sufficiently. In addition to
the clean time that was programmed, you must allow about
1 additional hour for the oven to cool before you will be
able to open the oven door.
To start Delay Start Self clean:
1.
Be sure the oven is empty and all oven racks are removed.
Be sure oven door is completely closed.
2. Be sure the clock shows the correct time of day.
3. Press Delay Start.
4. Press and hold the
self clean cycle. Release the key when the desired start time
is displayed.
5. Press Self Clean key. The display will show
6. Press
or
once. The display will show 3:00 to
indicate the default 3 hour clean time is selected. To change
to a 2 or a 4 hour clean time press
or 4:00 appears in the display then release the arrow
key.
7.
After selecting the clean time Self Clean is set to activate,
the DOOR LOCKED indicator light will turn on and the oven
door will lock in advance of the starting time. Once the
starting time is reached, CLn will appear in the display and
the oven will begin the self clean cycle automatically.
If it becomes necessary to stop Self Clean when active:
1.
Press
.
STOP
STOP
2. If Self Clean has heated the oven to a high temperature,
allow enough time for the oven to cool and for the DOOR
LOCKED indicator light to turn off. When this indicator light
turns off the oven door may be opened.
3. Restart Self Clean if needed.
16
key to scroll to the time to start the
— — —
; until 2:00 appears
.
Advertisement
