Luggage Strap Holders - Yamaha MT-10 Owner's Manual

Spring preload:
Minimum (soft):
Distance A = 0.0 mm (0.00 in)
Standard:
Distance A = 2.0 mm (0.08 in)
Maximum (hard):
Distance A = 9.0 mm (0.35 in)
3. Tighten the locknut to the specified
torque. NOTICE: Always tighten
the locknut against the adjust-
ing ring, and then tighten the
locknut to the
torque.
[ECA22760]
Tightening torque:
Locknut:
25 N·m (2.5 kgf·m, 18 lb·ft)
WARNING
This shock absorber assembly con-
tains highly pressurized nitrogen
gas. Read and understand the fol-
lowing information before handling
the shock absorber assembly.

Do not tamper with or attempt to
open the cylinder assembly.

Do not subject the shock ab-
sorber assembly to an open
flame or other high heat source.
This may cause the unit to ex-
plode due to excessive gas
pressure.

Do not deform or damage the
cylinder in any way. Cylinder
damage will result in poor
damping performance.

Do not dispose of a damaged or
worn-out shock absorber as-
sembly yourself. Take the shock
specified absorber assembly to a Yamaha
dealer for any service.
EWA10222
Instrument and control functions

Luggage strap holders

1. Luggage strap holder
There is a luggage strap holder on each
passenger footrest.
5-35
EAU15152
1
2
3
4
1
5
6
7
8
9
10
11
12