Yamaha MT-10 Owner's Manual page 82

Periodic maintenance and adjustment
er A by removing the bolts and
1
quick fastener.
2
3
4
5
1. Quick fastener
6
2. Coolant reservoir cover A
3. Bolt
7
TIP
The quick fastener is removed by push-
8
ing in the center pin and then pulling the
fastener out.
9
10
11
12
1
2
6. Remove the coolant reservoir cov-
3
er B and coolant reservoir by re-
moving the bolts.
1
1. Bolt
2. Coolant reservoir cover B
3. Coolant reservoir
4. Coolant reservoir cap
5. Collar
7. Remove the collars and coolant
1. Coolant reservoir cap
2. Coolant reservoir
5
4
3
2
TIP
The quick fastener is installed by push-
ing out the center pin, inserting the fas-
tener into the cover, and then by
pushing the center pin flush with the
8-15
reservoir cap, and then turn the
coolant reservoir upside down to
empty it.
8. After the coolant is completely
drained, thoroughly flush the cool-
ing system with clean tap water.
9. Install the collars, coolant reservoir
and its covers by placing them in
the original position, and then in-
stalling the bolts and quickfastner.
1
2