Yamaha MT-10 Owner's Manual page 78

Periodic maintenance and adjustment
1
2
3
4
1. Engine oil level check window
5
2. Maximum level mark
3. Minimum level mark
6
4. If the engine oil is at or below the
minimum level mark, add sufficient
7
oil of the recommended type to
raise it to the correct level.
8
To change the engine oil (and filter)
1. Start the engine, warm it up for
9
several minutes, and then turn it
off.
10
2. Place an oil pan under the engine
to collect the used oil.
11
3. Remove the engine oil filler cap,
the engine oil drain bolt and its
gasket to drain the oil from the
12
crankcase.
1
2
3
1. Engine oil filler cap
1. Engine oil drain bolt
2. Gasket
TIP
Skip steps 4–6 if the oil filter cartridge is
not being replaced.
4. Remove the oil filter cartridge with
1
2
1
8-11
an oil filter wrench.
1
1. Oil filter cartridge
2. Oil filter wrench
TIP
An oil filter wrench is available at a
Yamaha dealer.
5. Apply a thin coat of clean engine
oil to the O-ring of the new oil filter
cartridge.
2