Exup System; Auxiliary Dc Jack - Yamaha MT-10 Owner's Manual

Instrument and control functions
1

EXUP system

This model is equipped with Yamaha's
EXUP (EXhaust Ultimate Power valve)
2
system. This system boosts engine
power by means of a valve that controls
3
exhaust flow within the exhaust cham-
ber.
4
NOTICE
The EXUP system has been set and
5
extensively tested at the Yamaha
factory. Changing these settings
6
without sufficient technical knowl-
edge may result in poor perfor-
7
mance of or damage to the engine.
8
9
10
11
12
EAU67050

Auxiliary DC jack

WARNING
To prevent electrical shock or
short-circuiting, make sure that the
cap is installed when the auxiliary
DC jack is not being used.
ECA15611
NOTICE
The accessory connected to the
auxiliary DC jack should not be used
with the engine turned off, and the
load must never exceed 12 W (1.0 A),
otherwise the fuse may blow or the
battery may discharge.
This vehicle is equipped with an auxilia-
ry DC jack.
A 12-V accessory connected to the
auxiliary DC jack can be used when the
key is in the "ON" position and should
only be used when the engine is run-
ning.
To use the auxiliary DC jack
1. Turn the key to "OFF".
2. Remove the auxiliary DC jack cap.
EAU49453
EWA14361
ECA15432
1. Auxiliary DC jack cap
1. Auxiliary DC jack
5-36
3. Turn the accessory off.
4. Insert the accessory plug into the
auxiliary DC jack.
5. Turn the key to "ON", and then
start the engine. (See page 7-1.)
6. Turn the accessory on.
1
1