Drainage - Miele TX2070 Operating Instructions Manual

Installation and connection

Drainage

The machine drains via a drain pump
with a delivery head of 1 metre. The
drain hose must not be kinked as this
restricts drainage. The swivel elbow at
the end of the hose can be turned in ei‐
ther direction, or can be detached if re‐
quired, with a sharp twist and pull.
If required, the drain hose can be exten‐
ded to a length of 5 m. The necessary
parts can be purchased from Miele.
For a delivery head of more than 1 m
(up to a max. of 1.8 m) a replacement
drain pump will need to be fitted.
Please contact Miele for advice.
If necessary, the drain hose can be ex‐
tended to a length of 2.5 m. The neces‐
sary parts can be purchased from
Miele.
Drain hose connection:
1. Direct into a sink or basin:
Please note:
– Hook the hose over the edge and
secure.
– Make sure that the water can drain
away freely without hindrance.
Otherwise there is a risk of water
overflowing or of some of the
drained water being sucked back
into the machine.
2. Connected securely to a plastic drain
pipe with a rubber nipple. There is no
need to use a siphon.
3. Connected securely to a floor gully.
4. Connected securely to a standpipe.
84
Please note:
a Adapter
b Nut
c Hose clip
d End of the hose
 Fit the adapter  to the sink drain
outlet using the nut .
 Attach the end of the hose  to the
adapter .
 Use a screwdriver to tighten the hose
clip  up close to the nut.