Troubleshooting - DeLonghi Pinguino PAC AN112 SILENT Instruction Manual

TROUBLESHOOTING

Check the following points before calling the authorised Technical Service Centre in your area.
PROBLEMS
The air conditioner does not turn on
The air conditioner works for a short
period of time
The air conditioner runs but does not
cool the room
During operation there is an unpleasant
odour in the room
The air conditioner does not work for
about 3 minutes from restart
The display shows the
one of the following messages:
HL/PF
CAUSES
it is not plugged in
there is no power
the internal protection device was
triggered
the air exhaust hose is obstructed or
bent
an obstruction is impeding air exhaust
outside
windows, doors, drapes open
there is some heat source in the room
(oven, hair dryer, etc.)
the air exhaust hose is disconnected
from the appliance
dust filters clogged
the technical characteristics of the
appliance are not suitable for cooling the
room where it is located
dust filters clogged
to protect the compressor there is an
internal device that delays startup for
about 3 minutes from restart
The appliance has a self-diagnosis
symbol with
system that identifies some operating
errors.
SOLUTIONS
plug it in
wait
call the help centre
correctly position the air exhaust
hose, limiting the length and curves
as much as possible and avoiding any
obstructions
identify and remove the obstacles that
impede air exhaust outside
close the windows, doors and drapes,
keeping in mind the "recommendations
for proper use"
eliminate the heat source
attach the air exhaust hose to the
housing on the back of the appliance
(fig.1)
clean or replace the filters as previously
described
clean or replace the filters as previously
described
wait; this time delay from restart is
normal
refer to the SELF-DIAGNOSIS chapter
25