Hardware Description; Front Panel - Planet SGSW-4802 User Manual

This product series provide three different running speed – 10Mbps, 100Mbps, and 1000Mbps in the
same switch and automatically distinguish the speed of incoming connection.
This section describes the hardware features of SGSW-4802. For easier management and control of the
switch, familiarize yourself with its display indicators, and ports. Front panel illustrations in this chapter
display the unit LED indicators. Before connecting any network device to the switch, read this chapter
carefully
There are following option module for expansion:
l 1-Port 100Base-FX Managed Fiber Module (SC/ST, Multi-mode fiber)
l 1-port 100Base-FX Fast Ethernet Module (SC, Single-mode fiber, 15km)
l
1-Port Gigabit 1000Base-T Managed Switch Module
l 1-Port Gigabit 1000Base-SX/LX Managed Fiber Module

2.1 Front Panel

The Front Panel of the SGSW-4802 Managed Switch consists of 48x auto-sensing 10/100Mbps
Ethernet RJ-45 Ports, two optional expansion slots, and Console port. The LED Indicators are also
located on the front panel of the Switch.
Console
38400, 8, N, 1
2.1.1 LED indicators
SGSW-4802
PWR
Link
(could be three kinds of meaning, varies with the Mode button)
Mode:
ACT
FDX
100
2.1.2 Buttons indicators
SGSW-4802
RESET
MODE
SGSW-4802 Switch front panel
Green Lit on: Power on
Lit off: power off
Green Lit on: the connection is good
Lit off: the port is disabled or not detecting a link
Green Lit on: the connection is good.
Blink: The port is receiving or transmitting data
Green Lit on: the port run at full-duplex
Blink: Half-Duplex/ Collision
Off: Half-duplex or not connected
Green Lit on: run at 100Mbps
Lit off: run at 10Mbps or not connected
When press this button, Switch will reboot
Hold the button for at least 5 seconds, the LED will turns to the next LED in
cycle. (ACT àFDXàSpeedàACT)

2. HARDWARE DESCRIPTION

25 27 29
50 26 28 30
1 3 5
49
2 4 6
4
31 33 35 37 39 41
32 34 36 38 40 42
7 9 11 13 15 17
8 10 12 14 16 18
43 45 47
44 46 48
19 21 23
20 22 24