Table of Contents
Advertisement
•
•
The G35 FWT is compatible with most analog PBXs on the market.
G35 FWT connectivity to the analog trunk of the PBX
If the PBX fulfils the requirements for FWT connectivity, listed above,
follow all the installation steps as described in the topic Installing the
FWT on the Wall documented on page 12.
If you are using an analog PBX – disconnect the telephone you have
used to enter the PIN and test the FWT, and connect the analog trunk
cable from the PBX to the FWT telephone line interface.
Check your PBX programming guide to see how to program your PBX
to route certain calls through the FWT trunk if you are using a Least Cost
Routing (LCR) programmed PBX. Once LCR is programmed, make a
call to a mobile telephone number. See if the call is established through
the FWT and check the speech quality.
18
The PBX can be programmed to utilize Least Cost Routing (LCR), if
available, to automatically choose the trunk where the G35 FWT is
connected.
If the PBX does not offer LCR, choose the trunk where the FWT is
connected manually with a special dialed prefix. Check the installa-
tion in the same way as before.
Note: A minimum distance of 3 meters between the G35 FWT
and the PBX is recommended. The cable distance between the
PBX and the G35 FWT should not exceed 600 meters, and the
connection cable should be at least 0.4mm
Warning: If you install more than one G35 FWT to a PBX, their
antennas have to be separated by 20 cm in height or 2 meters in
the horizontal.
Fixed Wireless Terminal: G30 & G35
2
in diameter.
Advertisement
Table of Contents
