Page 24
4. Wireless ID Settings 1. Wireless Settings Change the wireless channels and wireless ID to avoid interference You can switch between normal flash and wireless flash. For normal flash shooting, be sure to set the wireless setting to OFF. for it can only be triggered after the wireless IDs and channels of the Transmitter unit and the Receiver unit are set to the same.Press the Transmitter Unit Setting <MENU>flash button to enter C.Fn ID.
Page 26
XPro and X2T series: Set the C.Fn-DIST to 0-30m. X3 Series: Set the triggering distance to 0-30m. 4. Whether the flash trigger and the receiver end equipment are in the low battery states or not →Please replace the battery(the flash trigger is recommended to use 1.5V disposable alkaline battery).
Operating frequency:2400MHz-2483.5MHz Maximum EIRP Power:4.73dBm Declaration of Conformity GODOX Photo Equipment Co.,Ltd. hereby declares that this equipment are in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. In accordance with Article 10(2) and Article 10(10), this product is allowed to be used in all EU member states.For...
Need help?
Do you have a question about the VING V860III P and is the answer not in the manual?
Questions and answers