Furuno VR-7000 Installation Manual page 47

2.7 Video LAN Converter IF-7100
The video LAN converter converts the radar video signal to a LAN signal.
Note 1: Do not connect/disconnect the DVI connectors while the turning the power on.
Note 2: Turn on or off the IF-7100 and connected equipment (radar or ECDIS proces-
sor unit) in the order shown below.
• Turning the power on: Tun on the IF-7100 before the connected equipment.
• Turning the power off: Turn off the connected equipment before the IF-7100.
Ground terminal
To ship's earth
*: Do not input the RGB signal to the video LAN converter. The RGB ports are pre-
pared for future use. If you need to input the RGB signal, use the RGB-DVI convert-
er shown below to convert to the DVI signal.
RGB-DVI converter: RS-1503A (maker: IMAGENICS)
Connections
1. Remove the outside cover of the video LAN converter; hold the right and left sides
of the cover and pull the cover outward.
2. Remove eight binding screws (M3x6) to detach the chassis cover.
Binding screws (8 pcs)
Power cable entrance
Chassis cover
RGB1 port*
No use
RGB2 port*
No use
DVI2 port
To Radar display 2
DVI1 port
To Radar display 1
2. WIRING
Network port
To the DCU
2-17