Remote Alarm Panel Vr-7017 - Furuno VR-7000 Installation Manual

1. MOUNTING
1.4

Remote Alarm Panel VR-7017

Mounting considerations
Select a mounting location, keeping in mind in the following points:
• Locate the unit away from heat sources.
• Select a location where the shock and vibration are minimal.
• Locate the unit away from places subject to water splash and rain.
• Make the maintenance space shown in the outline drawing for maintenance and
checking purpose.
• A magnetic compass will be affected if the unit is placed too close to the magnetic
compass. Observe the compass safe distances at the front of this manual to prevent
interference to a magnetic compass.
• Select a mounting location considering the length of the cable to be connected to
this unit.
Mounting
The remote alarm panel is designed to be flush-mounted in a console.
1. Make a mounting hole in the mounting location and prepare four pilot holes, refer-
ring to the outline drawing at the back of this manual.
2. Remove two binding screws (M3x6) to detach the back cover of the unit.
Remote alarm panel
3. Pass the cable through the mounting hole.
4. Connect the cable to the unit. For details of connection and wiring, see section 2.4
and interconnection diagram at the back of this manual.
5. After wiring, reattach the back cover.
Set the tabs on the back cover to the holes in the unit, then fix it with the screws.
1-10
Binding screw
(2 pcs)
Back cover
Back cover Back cover